Brushing your film flat on the glass

flat rock stan · May 3, 2014

For years while teaching people to tint and occasionally myself, I crease the film when i am starting to squeegee it out. I sometimes have had people use the soft black squeegee first then the max but now i teach um how to use the Brush to get the film flat and ready for the max.

cheers all

Stan

TomTint · May 3, 2014

Nice vid Stan, for the life of me I can't see how back rolling a rear glass does not invite contamination. Between the top and bottom edges of the roll hitting the headliner and rear shelf, then fingers touching the adhesive while RR ing, and the dirt that could possibly be on the liner itself. .. I was always a frankly guy myself

TintDude · May 3, 2014

Nice shirt Stan.

flat rock stan · May 3, 2014

Nice vid Stan, for the life of me I can't see how back rolling a rear glass does not invite contamination. Between the top and bottom edges of the roll hitting the headliner and rear shelf, then fingers touching the adhesive while RR ing, and the dirt that could possibly be on the liner itself. .. I was always a frankly guy myself

i have best luck with r roll but when doing customers car always use lots of tape around the edge and roll in high then push down. leaving the small area dry keeps the liner in place over the glue avoiding contamination. This tip is mostly for new people but all might pick something up!

thanks Tom, your the best

stan