Jump to content

Last One To Post #877


Recommended Posts

@highplains similar to @Tintmaster08 Said:  First thing I do:

I normally spray a ton of slip on it, then run a while hard card across to break up the rubber sticking to the glass. After I stuff a couple bones in there, and proceed to tint the rest of the car. When I get to laying the B-glass it generally slides under no problem.  Definitely has to be one of the more ridiculous changes ever. The car was fine without it for how many years?

Link to comment
Share on other sites

5 hours ago, jh812 said:

Did you pull that deck? 

:yep was a bit of a pain in the ass but I managed

 

4 hours ago, Super Dave said:

@highplains similar to @Tintmaster08 Said:  First thing I do:

I normally spray a ton of slip on it, then run a while hard card across to break up the rubber sticking to the glass. After I stuff a couple bones in there, and proceed to tint the rest of the car. When I get to laying the B-glass it generally slides under no problem.  Definitely has to be one of the more ridiculous changes ever. The car was fine without it for how many years?

I know right? I wound up pulling the deck and there is a big RF receiver right dead center, probably why the seal is there, I'm going to assume that's it anyway. 

 

 

Came out nice in the end

20180726_160813.jpg.0333886e87b19716b54b3a00d0a1b30e.jpg

Edited by highplains
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...