-
Posts
32,636 -
Joined
-
Last visited
Reputation Activity
-
jh812 reacted to Bham in 2019 Lexus nx300
I want to know if these window " can be tinted one time " using just install soap and a yellow turbo. ??
Has anyone tinted these successfully without all the scraping of the coating and crap ??
Is there any damage or change in the coating after you install film ?
These are serious questions and inquiring minds NEED to know
-
jh812 reacted to no ma'am in New 3 series 2020?
Update to the update.... 2 screws on every panel, 1 behind handle 1 below armrest. Pull seal first tint window then pull screws pop panel off to put seal back in
-
jh812 got a reaction from Stewy in Smart Car Fortwo
Nah they're relatively easy nothing special. You can just about use a sun strip roll for the back glass 😂
-
jh812 got a reaction from Tint Slayer in Avery auto films (used to be Hanita)
No that was on his personal Facebook. Honestly can't say tint Slayer, I tried a little of it and absolutely hated it. That was before the buy out however.
-
jh812 reacted to wade_660 in Tinting a Full Semi
Not that it would change my decision but is anything over 40 hours considered overtime? I don’t know what it would take to get me to do that job, but it would be a lot and probably more of a commission structure as opposed to hourly. Like someone said earlier. I work too hard to get paid hourly
-
jh812 got a reaction from quality tintz in Llumar curling
That's the most polite way to put that a film sucks
-
jh812 got a reaction from Tint Slayer in Tinting a Full Semi
https://getyarn.io/yarn-clip/ceb2e685-e2fb-411a-90b9-f0ed9cdbe67a
-
-
jh812 got a reaction from pbalentine in Tinting a Full Semi
By chance I tinted three semis today no shield eff 25 an hour on that 😂😂😂
-
-
jh812 got a reaction from quality tintz in Not tucking film anymore
I knew before even pulling this thread up you started it
-
-
jh812 got a reaction from highplains in Tinting a Full Semi
https://getyarn.io/yarn-clip/ceb2e685-e2fb-411a-90b9-f0ed9cdbe67a
-
jh812 got a reaction from Bham in Tinting a Full Semi
https://getyarn.io/yarn-clip/ceb2e685-e2fb-411a-90b9-f0ed9cdbe67a
-
-
jh812 reacted to TintDude in Newbie window tintz installer looking for tintz!
Fair enough. The little bubbles you mention are contamination, little pieces of dirt trapped in the film. It's not the film's fault, neither are 'lines' which are probably creases. A good film isn't going to fix these, only improving your skills will.
For a better quality film, I'd visit Express linked in the banner above this thread.
-
jh812 reacted to bennett5 in 2019 Subaru Forester
3 screws 1 at opener 2 under grab handle cut back tight leave front long front opera tucks nice leave bottom a little long
-
-
-
-
-
-
-
jh812 got a reaction from Tint Eastwood in Is this normal? Bubbles around edges after tint job
Don't you miss auto 😂?
-